就过去半年出现的产品质量问题召开“产品质量培训”会议。 On May 31, 2018, Wangzhuo Rubber & Plastic Technology (Shanghai) Co., Ltd. held a “Product Quality Training” meeting on product quality issues that occurred in the past six months. At the meeting, the "three no policies" of quality were proposed-no defective products were accepted, no defective products were produced, and no defective products were leaked out; the quality management team inspected and supervised the whole process.
The "Product Quality Training" conference includes:
I. Illustration of inspection tools
Make sure everyone uses product inspection tools to avoid errors in production operations.
2. Preparation before production (check list)
Confirm the materials and molds, and check whether they are consistent with the numbers on the process card.
Measurement and recording of the first and last pieces of production
Record the time after measuring the size of the first product, and measure the size of the last product again.
Fourth, workshop visual kanban management instructions
Listed various product quality problems, and annotated causes and solutions to alert.
V. 5S of the warehouse / workshop and the second floor workshop on the south side
Standardize 5S operations; often organize, always rectify, often clean, often standard, and often self-discipline.
Six, carton sealing requirements
Standardize product packaging and sealing, protect the product from damage during transportation, and enhance the company's product image.
The above is the content of this "product quality training".
，转载请注明出处 Copyright http://webbeech.com , please indicate the source when reproduced